Latinica

[ZivicAleksandar]

Uspeo sam nekako da generisem pomenuti isapnp.conf,
a u /dev imam nekakav modem koji je u stvari simbolicki link na /ttyS2
koji pa uopste i nepostoji.
Mojo pitanje glasi kako da mu dodam COM port, a ovde mije u clipbordu i isapnp.conf pa ako nekog zanima ili taj neko moze da mi pomogne neka ga edituje po svom misljenju ince u W2k za isa komponente stoji ovako:
Modem dakle: COM3 IRQ7 I/O range 03e8-03ef
Mrezna: IRQ10 I/O range 02d0-02df

Pa koje voljan nek mi barem nznaci sha da radim
Doduse cackao sam nesto kod IRQ4 jer mi se njego I/O cinio odgovarajucim, ali kako sam ga izcackao boga pitaj.
Unapred hvala

# $Id: pnpdump_main.c,v 1.27 2001/04/30 21:54:53 fox Exp $
# Release isapnptools-1.26
#
# This is free software, see the sources for details.
# This software has NO WARRANTY, use at your OWN RISK
#
# For details of the output file format, see isapnp.conf(5)
#
# For latest information and FAQ on isapnp and pnpdump see:
# http://www.roestock.demon.co.uk/isapnptools/
#
# Compiler flags: -DREALTIME -DHAVE_PROC -DENABLE_PCI -DHAVE_SCHED_SETSCHEDULER -DHAVE_NANOSLEEP -DWANT_TO_VALIDATE
#
# Trying port address 0273
# Board 1 has serial identifier a6 96 f8 c5 aa 90 30 72 56
# Board 2 has serial identifier 39 97 16 e0 17 94 50 6d 50

# (DEBUG)
(READPORT 0x0273)
(ISOLATE CLEAR)
(IDENTIFY *)
(VERBOSITY 2)
(CONFLICT (IO FATAL)(IRQ FATAL)(DMA FATAL)(MEM FATAL)) # or WARNING

# Card 1: (serial identifier a6 96 f8 c5 aa 90 30 72 56)
# Vendor Id USR3090, Serial Number 2532885930, checksum 0xA6.
# Version 1.0, Vendor version 0.0
# ANSI string –>U.S. Robotics 56K Voice INT3Com 3C509B EtherLink III<–
#
# Logical device id TCM5094
# Device supports I/O range check register
# Device supports vendor reserved register @ 0x38
# Device supports vendor reserved register @ 0x39
# Device supports vendor reserved register @ 0x3a
# Device supports vendor reserved register @ 0x3c
# Device supports vendor reserved register @ 0x3e
#
# Edit the entries below to uncomment out the configuration required.
# Note that only the first value of any range is given, this may be changed if required
# Don't forget to uncomment the activate (ACT Y) when happy

(CONFIGURE TCM5094/2534858775 (LD 0
# Compatible device id PNP80f7
# IRQ 3, 5, 7, 9, 10, 11, 12 or 15.
# High true, edge sensitive interrupt (by default)
# (INT 0 (IRQ 3 (MODE +E)))
# Logical device decodes 16 bit IO address lines
# Minimum IO base address 0x0210
# Maximum IO base address 0x03e0
# IO base alignment 16 bytes
# Number of IO addresses required: 16
# (IO 0 (SIZE 16) (BASE 0x0210) (CHECK))
(NAME "TCM5094/2534858775[0]{3Com 3C509B EtherLink III}")
# (ACT Y)
))
# End tag… Checksum 0x00 (OK)

# Returns all cards to the "Wait for Key" state
(WAITFORKEY)

PS
STO JE DOBAR OVAJ COMMANDERov PLUGIN

[ZivicAleksandar]

😕 Probaj da mu smanjis konekciju ispod 11520 na nekih 3800 ili tako nesto, kod mene na PAP/CHAP, a dok mu nisam smanjio brzinu tj kolicinu nisam mogao da se konektujem 😉

[ZivicAleksandar]

Stvarno je dobra, ali mi neradi mail, tj. ni POP3 ni SMTP, a Xine bez problema, amo sto mi je malo neprakticno, pa imali neko ideju zasto Mozilla ima ona tri SMTP-a pod advanced, posle cijeg obilaska nece da mi zatvori acount setings na OK nego samo na cancel ili onaj X u desnom gornjem cosku? A uz to i neradi.
Verzija Mozille je kroz Help>Abot Mozilla =

Mozilla 1.1

Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.1) Gecko/20020826

Ako postoji novija kako da je nadjem i instaliram tj. samo Upgread-ujem, ako je moguce ❓

[Autor]

Članci