- This topic has 6 одговора, 5 гласова, and was last updated 18 years, 8 months раније by
.
-
Чланци
-
Pokusao sam da instaliram drajver za stampac koji je u gz.sh obliku sa sh ime_paketa i izbacio mi je sledecu poruku:
Verifying archive integrity…OK
Uncompressing Lexmark Printer Drivertrap: usage: trap [-lp] [arg signal_spec …]Isto mi se desilo i pri instalaciji patcha za jednu igru koji je bio u .sh obliku.
Sa instalacijom nvidia drajvera .sh npr nemam problema.
Jel moze neko da mi rastumaci sta ovo znaci?Šta se kaže u dokumentciji tog drajvera. Da li ima README ili
INSTALL fajl? Da li postoji uputstvo na sajtu sa kojeg si skinuo drajver?Koji Lexmark,OS….
Ja koristim Lexmark Z25 a, OS je Mandrake 10.1 i radi odlicno!!!lexmarkz35-CUPS-2.0-1.gz.sh ove drajvere sam njos davno naso na netu i rade ok
[code]
root@darkstar:~# help trap
trap: trap [-lp] [arg signal_spec …]
The command ARG is to be read and executed when the shell receives
signal(s) SIGNAL_SPEC. If ARG is absent (and a single SIGNAL_SPEC
is supplied) or `-‘, each specified signal is reset to its original
value. If ARG is the null string each SIGNAL_SPEC is ignored by the
shell and by the commands it invokes. If a SIGNAL_SPEC is EXIT (0)
the command ARG is executed on exit from the shell. If a SIGNAL_SPEC
is DEBUG, ARG is executed after every simple command. If the`-p’ option
is supplied then the trap commands associated with each SIGNAL_SPEC are
displayed. If no arguments are supplied or if only `-p’ is given, trap
prints the list of commands associated with each signal. Each SIGNAL_SPEC
is either a signal name in or a signal number. Signal names
are case insensitive and the SIG prefix is optional. `trap -l’ prints
a list of signal names and their corresponding numbers. Note that a
signal can be sent to the shell with “kill -signal $$”.
root@darkstar:~#[/code]
So … ostaju ti dve stvari
[code]
sh file.sh –help[/code]
pa nam prekopiraj shta kazhe mada ne verujem da tjesh mnogo dobiti … Medjutim mozhda dobijesh opciju da odpakujesh drajver i instalirash ruchno
[code]
editujesh file.sh
[/code]
nadjesh gde koristi “trap” (inache se radi o shell scripti)i ispravish greshku sam
[code]
Nadjesh drugu verziju drajvera koja ima ispravnu instalaciju ili podrzhava tvoju verziju sh-a[/code]Otpakovao sam arhivu sa sh imepaketa.sh -keep. U dobijenom folderu sam nasao drajvere u obliku RPM paketa koje sa rpm2tgz-ovao, instalirao i sad stampac sljaka 😆
Мораш бити пријављен да би поставио коментар у овој теми.