Početak›Forumi›Linuks distribucije›Mandriva›Hardver›DRAJVER ZA ZVUCHNU KARTU!!! Audio driver for CM8338/CM8738 chips by Chen-Li Tien
- This topic has 5 odgovora, 4 glasa, and was last updated 16 years, 3 months ranije by Zarko.
-
AutorČlanci
-
27. decembar 2007. u 3:21 pm #9671sodaUčesnik
DRAJVER ZA ZVUCHNU KARTU!!! Audio driver for CM8338/CM8738 chips by Chen-Li Tien
u pitanju je … Audio driver for CM8338/CM8738 chips by Chen-Li Tien
ima instalaciju za linux koju ja uopste ne razumem (a kako bih razumeo kada sam totalno nov na linuxu) pa bih molio vas profesionalce da mi pomognete oko ove instalacije (: btw koristim linux ubuntu 7.10 ako to ima nekakve veze…evo celog uputstva koje je na cd-u…
ako moze neko da mi ga pojednostavi…
bio bih mu zahvalan (:Audio driver for CM8338/CM8738 chips by Chen-Li Tien
HARDWARE SUPPORTED
================================================================================
C-Media CMI8338
C-Media CMI8738
On-board C-Media chips
WHAT’S NEW
================================================================================
1. Support modem interface for 8738. (select in kernel configuration)
2. Enable S/PDIF-in to S/PDIF-out (S/PDIF loop).
3. Enable 4 channels analog duplicate mode on 3 jack or 4 jack
configurateion.
4. Enable joystick support. (joystick driver needed)
STEPS TO BUILD DRIVER
================================================================================
1. Backup the Config.in and Makefile in the sound driver directory
(/usr/src/linux/driver/sound).
The Configure.help provide help when you config driver in step
4, please backup the original one (/usr/src/linux/Document) and
copy this file.
The cmpci is document for the driver in detail, please copy it
to /usr/src/linux/Document/sound so you can refer it. Backup if
there is already one.
2. Extract the tar file by ‘tar xvzf cmpci-xx.tar.gz’ in the above
directory.
3. Change directory to /usr/src/linux
4. Config cm8338 driver by ‘make menuconfig’, ‘make config’ or
‘make xconfig’ command.
5. Please select Sound Card (CONFIG_SOUND=m) support and CMPCI
driver (CONFIG_SOUND_CMPCI=m) as modules. Resident mode not tested.
For driver option, please refer ‘DRIVER PARAMETER’
6. Compile the kernel if necessary.
7. Compile the modules by ‘make modules’.
8. Install the modules by ‘make modules_install’
INSTALL DRIVER
================================================================================
1. Before first time to run the driver, create module dependency by
‘depmod -a’
2. To install the driver manually, enter ‘modprobe cmpci’.
3. Driver installation for various distributions:
a. Slackware 4.0
Add the ‘modprobe cmpci’ command in your /etc/rc.d/rc.modules
file.so you can start the driver automatically each time booting.
b. Caldera OpenLinux 2.2
Use LISA to load the cmpci module.
c. RedHat 6.0 and S.u.S.E. 6.1
Add following command in /etc/conf.modules:
alias sound cmpci
also visit http://www.cmedia.com.tw for installation instruction.
DRIVER PARAMETER
================================================================================
Some functions for the cm8738 can be configured in Kernel Configuration
or modules parameters. Set these parameters to 1 to enable.
spdif_loop: Enable S/PDIF loop, this route S/PDIF-in to S/PDIF-out
directly.
four_ch: Enable 4 channels mode, rear-out or line-in will output
the same as line-out.
rear_out: Enable this if you have independent rear-out jacket on
your sound card, otherwise line-in will be used as
rear-out.
modem: You will need to set this parameter if you want to use
the HSP modem. You need install the pctel.o, the modem
driver itself.
joystich: Enable joystick. You will need to install Linux joystick
driver.
27. decembar 2007. u 3:57 pm #66294kosmiUčesnikTaj drajver je za 2.4 kernele verovatno, ako koristiš 2.6 kernel on je već tamo. Proveri sa:
[code]modprobe -all|grep snd-cmipci[/code]
27. decembar 2007. u 6:41 pm #66295sodaUčesnikda koristim 2.6
interesuje me ako bi neko mogao detaljno da mi objasni kako da inst. driver za ovu zvuchnu… !!! nadam se da to netje biti problem… (:
ipak tek sam par sati korisnik linuxa (:27. decembar 2007. u 6:50 pm #66296AndersenUčesnikAko koristis 2.6 kernel taj drajver bi trebao je vec instaliran,koliko se ja secam kod mene je tu zvucnu prepoznavala i pokretala cak i neka stara verzija Knoppix-a?Ne verujem da moras da ga instaliras naknadno.. ???
27. decembar 2007. u 7:04 pm #66297sodaUčesnikpa ne znam samo znam da kada sam instalirao ubuntu da sam imao zvuk… a odjednom ga sada nemam… mozda sam ja nesto s*ebao… kako da proverim dal imam driver ?
27. decembar 2007. u 8:35 pm #66298ZarkoUčesnikOtkucaj u terminal $lsmod | grep cmi
Imam istu zvucnu i dobijam:
[code]snd_cmipci 37024 3
gameport 16776 1 snd_cmipci
snd_pcm 80388 3 snd_cmipci,snd_pcm_oss
snd_opl3_lib 11520 1 snd_cmipci
snd_mpu401_uart 9600 1 snd_cmipci
snd 54660 16 snd_cmipci,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_opl3_lib,snd_hwdep,snd_mpu401_uart,snd_seq_oss,snd_rawmidi,snd_seq,snd_timer,snd_seq_device[/code]Ako dobijas isto drajver ti je OK. Mislim da je glavni modlul(drajver) samo ovaj snd_cmipci pa tako ako ga nemas otkucaj[code]$sudo modprobe snd_cmipci[/code]
-
AutorČlanci
Forum ‘Hardver’ je zaključan za nove teme i odgovore.